![]() The reason for this is that the Memory Cells doesn't completely cut of the power for the Auto Turrets when they are inactive. The Electrical Branch powering the Door Controllers should be replaced with a Splitter and it's power input should be lowered to 3 rW.Īfter the Memory Cells that toggles the Auto Turrets you need to add a Blocker as for the "Block Passthrough" input you should take the remaining power from the Siren Light and use that. The other output on the electrical branch can be feed into the splitter that feeds the memory cells. For this, I would recommend using a Electrical Branch with a value of 7 rW and feed that into a splitter and connect the pressure pads to the splitter. The Pressure Pads are not receiving any power, they need at least 2 rW each to work. Nice circuit, but there are a few problems with it: in addition it can be used as tactical on/off switch or to reload under active duty. this prevent a easy destruction and a further restart of empty turrets and matching doors. this turn of the turret and the matching doors will close. ![]() The in line turret memory cell will switch in the event of no ammo signal from the turret. The search and destroy activation timer will feed in the first blocker input (the blocker in line with the xor-chain) witch prevent a search and destroy shut down of the turrets in the event of early leaving the sensors range (HBHF in this case). therefore the second blocker will be deactivated and the turrets, doors and minimal activation timmer (time to search and destroy for the turrets) will start up. the possible one (multible xor-switchs) will be eliminated by the first blocker consumption. In the event of enemy dedection by a HBHF (or by a active turret target or desctruction of hbhf or by RF remote control) only zero or one engery (multible activated xor-switchs) arrives at the end of the xor-chain. The xor-chain is supplied with two energy which is enough to run trugh the first blocker and feeds the input of the second blocker (the block in line with the main power line and therefore resulting low standby consumption). ![]() = Jim`s Large Battery Auto Turret Defense System =-Ĭriticism, suggestions and questions are welcome!Ī version for rustrician emulation purposes (slightly reduced xor-chain, functional the same)įast forward functional description for a better understanding With ideas from _PYRO42_and recent smart turret contributions here on r/rustrician My last attempt had a bad mistake □ a hasty try on battery operation ![]()
0 Comments
Leave a Reply. |